Just because a diamond cut wheels contains the hardest material known to man does not mean that it should be handled by deputy. These are tools for precision implantation. Although larger than a scalpel, they cannot perform an operation accurately unless they receive adequate care. To this end, a list of “can do and not do” is listed here, which will prevent the diamond sintered form from being treated cruelly.
Do not apply excessive cutting force
The on-site foreman may be shaking his head to stare at his watch, but don’t let this pressure affect the work. Do not rush to work by pressing down on the tool handle. Keep in mind that diamond cut wheels are not actually cut, but wear.
Don’t be busy with work
Just like the problem of excessive force, urgent work will not produce good results. Even if they do happen, imagine damaging. The tool motor is overloaded, the diamond cut wheels builds up prematurely, and the diamond cut wheels bond becomes so hot that the diamond is eventually covered in the glaze that slows down the working speed.
Do use the right diamond cut wheels for a working attitude
Universal discs can be used, but relying on common tool types will inevitably slow down the work. If the material to be cut is concrete, use a diamond cut wheels that is specifically designed to cut concrete. Any other material is the same, so choose the diamond cutting tool that is right for the job.
Please check the tool
Focusing on a diamond cut wheels is possible because the operator needs to choose the right cutting medium. Again, you must pay attention to the tool check. Install the grinding wheel on a properly sized diamond cut wheels shaft and ensure a secure fit.
Don’t ignore the “wet” setting
If a wet disc is used, it cannot be operated under dry conditions. If a longer functional life is to be achieved, the cooling water should flow down from both sides of the 6 diamond grinding wheel. By the way, the safety guard is mandatory, so when the safety guard is in place, make sure the water supply enters the cutting edge.
Do not skip tool preflight
Visually inspect the diamond cut wheels. Is it broken or damaged in other ways? Then, check the mounting and flange edges while the tool is still not disconnected. There should be no blockage around the flange and the mounting nut must be completely fixed.
The “do and don’t do” list of diamond cut wheels flipped a few pages. But, fundamentally speaking, the right tool is the right way to work. Use the diamond cut wheels according to the manufacturer’s instructions and install the diamond cut wheels to securely install it and leave space around the tool flange. In short, take care of the diamond cut wheels, tool holders and their safety regulations while using the gears as described.